3600 Series IP Phone Installation Page 20
IP Office 4.0 15-601082 Issue 05a (22nd May 2007)
2. AVPP Installation and Configuration
2.1 AVPP Installation Requirements
Materials Required
The following equipment must be provided by the customer:
1. Power Outlet
Must accept the Avaya provided AC adapter.
2. Backboard space
The AVPP is designed to be wall mounted to ¾” plywood securely screwed to the wall. The
AVPP measures approximately 4 x 12.5 x 7 inches, and weighs about five pounds. The unit can
be wall mounted, vertically or horizontally, over ¾” plywood.
• Alternate Mounting
The AVPP can also be rack mounted using a rack mount kit (sold separately).
3. Screws
Required to mount the AVPP to the wall. Four #8 - ¾” panhead wood screws (or similar device)
are required.
4. Cat. 5 Cable
RJ-45 connector at the AVPP. Used for connection to the Ethernet switch.
5. AVPP Software
1. Using a web browser, browse to http://www.spectralink.com.
2. From the list on the left select RESOURCES.
3. Select Infrastructure.
4. Select NetLink SVP/AVPP Server.
Tools Required
1. Drills and Screwdrivers
Tools for mounted using the materials listed above.
2. DB-9 Female null modem cable
Required for initial PC access to the AVPP configuration.
3. PC with the following:
1. Terminal Emulation Program
Required for initial PC access to the AVPP configuration.
2. IP Office Manager Application
Required to configure the AVPP IP address in the IP Office configuration.
Information Required
1. AVPP IP Address, Subnet Mask and Default Gateway
The first AVPP must be given a fixed IP address. This address must also be on the same subnet
as the access points.
2. TFTP Server IP Address
For software updates, the AVPP checks the software it has against that found at the specified IP
address for its TFTP server.
To Next Page
Loading...
