3. Phone Configuration
3600 Series IP Phone Installation Page 41
IP Office 4.0 15-601082 Issue 05a (22nd May 2007)
3.4b 3641 and 3645 Phones
1. Do not perform this process until the preceding checks have been completed:
2. Set the phone into administration mode:
1. With the phone powered off, while pressing the START key press and release the END
key.
2. When the administration menu appears release the START key.
3. If the phone's administration password has been enabled, the phone will require that
password to be entered before it displays the administration menu. The default password
is 123456. This step is not required if the administration password has not been enabled.
3. Select Network Config.
1. The default mode for IP address operation is DHCP. The following is only required if the
phone needs to be switched to static IP address operation:
1. Select IP Addresses and then Static IP.
2. Set the IP Address, TFTP Server IP, Default Gateway and Subnet Mask
information as required.
3. Set the Call Server IP to the LAN address of the IP Office.
4. Set the Call Server Port to 1719.
5. Set the AVPP IP address.
2. Select SSID. Enter the SSID of the wireless network that the phone should use.
3. Select Security. Enter the wireless security settings that match those configured for the
wireless network.
4. Select Reg Domain. The regulatory domain must be set before the wireless frequency
and transmit power can be selected. Press LINE and then select the appropriate
regulatory domain. 01 = North America. 02 = Europe.
5. Once the regulatory domain has been set, the wireless mode can be selected (802.11a,
802.11b or 802.11b/g). The modes available may vary according to the regulatory
domain. If 802.11a is selected, the frequency band or bands to use can also be selected.
6. Once the wireless mode is selected, depending on that selection and the regulatory
domain, the Transmit Power can be selected.
4. Select Phone Config.
1. Select Telephony Protocol. The phones needs to be configured with a telephony
protocol number which then ensures the handset checks for the proper software files
each time it powers on. Set the value to 033.
1. To change the displayed number, press Select.
2. To scroll through the options, press Up or Down.
3. To select the displayed number, press Select.
2. Select IP Office and set this to Enable.
5. Power cycle the phone.
1. If the phones software needs to be updated the new software will now be downloaded
from the TFTP server. The status bar will increment fully across the display for each
function that is being performed in the download process.
2. Upon completion of the update process, the handset will re-boot with the new firmware.
6. The phone will ask for the extension and password. Enter the values required for the user on the
IP Office. Once these have been entered, the phone will register with IP Office. Note: The
password requested matches the IP Office user Login Code.
To Next Page
Loading...
