1. Set the switch on the bottom of the terminal for either line power or local power.
2. Plug in the M5317TDX terminal.
3. Press and hold down the RLS and HOLD keys as the terminal powers up.
4. Press MAINROM.
5. Press INSTALL.
6. Press ENGLISH or FRANCAIS for your choice of language.
7. Press the soft key of the TEI you want to set PHONE, DATA or X25.
Note:
Dynamic TEI is only supported with firmware version 2.0 or higher.
8. Enter * for dynamic TEI.
9. Enter the TEI on the terminal keypad for static TEI.
10. Press OK when you have finished setting the TEIs.
11. Enter the phone (voice) SPID. Press OK when finished.
12. Enter the data SPID. Press OK when finished.
13. Enter the data DN. Press OK when finished.
14. Press HEADSET until REAR displays.
15. Press SIGTYPE until MER1 displays.
16. Press A/MU until MU-LAW displays.
17. Press MORE.
18. Press DIALPLN until NATIONAL displays.
19. Press EXIT.
20. Press NO to execute SPM.
21. Press YES to enter datafill.
22. Press YES to delete existing datafill.
23. Press KEY# then use to keypad to enter the key number you want to program.
24. Press EDIT DN then use the keypad to enter the digits of the DN.
25. Press OK then SAVE after each DN.
26. Repeat
18 on page 78 to 25 on page 78 for each voice DN keypad you want.
27. Press INSTALL and begin at step 4 on page 78, If you entered incorrect data. If the
entries were correct, press EXIT.
28. Make a voice call to make sure the telephone is operational.
Configuring ISDN BRI hardware
78 ISDN Basic Rate Interface Installation and Commissioning March 2011
To Next Page
Loading...
