Avaya DECT - Page 50

Page 50 - IP Office Integration
Page 50 DECT - Installation Manual
DECT Integration 38HBKD0001SAH – Issue 14 (27th October 2003)
Installation Overview
To install DECT Integration software with IP Office the following steps
must be performed in sequence:
1. Perform the Site Survey (see page 8) and install the DECT Control
Unit (see page 16).
2. Register each DECT handset using the CCFP Administration program
(see page 25). The Local No. must be the extension number allocated
to the analogue port of the IP Office (see page 52).
3. Install DECT Configuration software on the PC running IP Office
Administration (see page 52). Connect the DECT to the PC using the
DCU to PC Programming Cable (see page 69).
4. DECT configuration must be licenced (see page 52) to utalize IP
Office Integration.
5. Configure, within the IP Office Manager program, each User (the
analogue port allocated to a DECT handset - see page 52).
6. Options:
- Make a DECT handset a slave of an IP Office desktop phone (see
page 52)
- Set Voicemail pick-up, from a DECT handset operating as a slave
of a desktop phone (see page 55).
7. On completion, the Voice Mail server must be switched on
(Programs/IP Office/VoiceMail).