Front view of Dell
™
PowerEdge
™
R630 Server
No. Item Icon Description
1 Power-On Indicator,
Power Button
The power-on indicator lights when the system power is on. The power
button controls the power supply output to the system.
Note:
On ACPI-compliant operating systems, turning off the system using
the power button causes the system to perform a graceful shutdown
before power to the system is turned off.
2 NMI Button Used to troubleshoot software and device driver errors when running
certain operating systems. This button can be pressed using the end of a
paper clip.
Use this button only if directed to do so by qualified support personnel or
by the operating system documentation.
3 System
Identification Button
The identification buttons on the front and back panels can be used to
locate a particular system within a rack. When one of these buttons is
pressed, the LCD panel on the front and the system status indicator on
the back flashes blue until one of the buttons are pressed again.
Press to toggle the system ID on and off. If the system stops responding
during POST, press and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC setup) press and hold
the button for more than 15 seconds.
4 USB Connectors (2) Allows you to insert USB devices to the system. The ports are USB 2.0-
compliant.
5 Optical Drive One DVD+/-RW drive.
Note:
DVD devices are data only.
Table continues…
Installing the new streaming and recording server
August 2017 Installing the Avaya Equinox Streaming and Recording Server 30
Comments on this document? infodev@avaya.com
To Next Page
Loading...
