d. From the left menu bar, click System Configuration.
e. Click Transcoder Configuration.
f. Enter the IP address or FQDN of the transcoder and click Finish.
The transcoder is running on the host operating system. The CP is running on a virtual
machine which runs on the host. The IP address/FQDN of the transcoder is the IP of
the host Windows
™
2012 server. When you are securing the system with certificates,
this address must match the address that you specify in the transcoder server
certificate.
Figure 16: Transcoder Registration
Next steps
Return to the Installation checklist on page 25 to see your next task.
Unregistering each of the components
If you plan to move a device to a different Equinox Streaming and Recording environment,
unregister the device before changing its location. If you do not unregister the device using the
Equinox Streaming and Recording Manager, you must unregister it using its local web interface
before you can register it to the new Equinox Streaming and Recording environment.
About this task
The process of unregistering is the same for all delivery nodes, virtual delivery nodes, and
conference points.
Procedure
1. Log in to Equinox Streaming and Recording.
2. Click the Devices tab.
3. From the Browse menu, select the device you want to access.
A list of devices of that type is displayed.
4. Click Advanced Options.
5. Select one of the devices.
The device details dialog is displayed.
Registering each of the components
August 2017 Installing the Avaya Equinox Streaming and Recording Server 63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
