Procedure
1. Log in to Equinox Streaming and Recording.
2. Click the Global Policies tab.
3. Click General Options.
4. Configure the settings, as described in
Table 13: Polling Settings on page 73.
Table 13: Polling Settings
Field Name Description
Conference Point Polling Frequency Specify how often the Equinox Streaming and
Recording Manager checks for device
configuration or status changes for each of the
conference points.
Delivery Node Polling Frequency Specify how often the Equinox Streaming and
Recording Manager checks for device
configuration or status changes for each of the
delivery nodes.
Network Address for Device Communication Enter the IP address or DNS name of the
Equinox Streaming and Recording Manager.
This is the address that the other devices
(delivery nodes, conference points, virtual
delivery nodes) will use to communicate with the
Equinox Streaming and Recording Manager. If
split-horizon DNS is being used, use the DNS
name for the Equinox Streaming and Recording
Manager. Since this address is used by the other
devices to communicate back to the Equinox
Streaming and Recording Manager, it is
important to specify the correct routable address.
Retain Deleted Recordings For For more information, see Administering Avaya
Equinox Streaming and Recording, which is
available on https://support.avaya.com/.
5. Click Save.
Adding and Modifying Equinox Streaming and Recording
Servers in Equinox Management
About this task
This section explains how to configure Avaya Equinox Streaming and Recording Server settings in
Equinox Management. For example, you can configure the URL of the Avaya Scopia Desktop
Server that users connect to in order to see broadcasts.
Adding and Modifying Equinox Streaming and Recording Servers in Equinox Management
August 2017 Installing the Avaya Equinox Streaming and Recording Server 73
Comments on this document? infodev@avaya.com
To Next Page
Loading...
