EasyManua.ls Logo

Avaya Equinox - Specifying Polling Intervals and the Network Address

Avaya Equinox
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Field Name Description
Source DN Select a delivery node. Alternatively, you can
select a delivery node from the Source Group
field.
Source Group Select a delivery node viewer group.
Alternatively, you can select a delivery node from
the Source DN field. The Source Group field
displays any viewer groups. A viewer group is a
group of delivery nodes and these groups offer
redundancy. If one of the delivery nodes in a
group is not available, an alternative delivery
node from the same group is selected.
Location Enter a location. The location must match a
location specified for a Scopia Elite MCU and/or
Equinox Media Server in Equinox Management.
If you are not specifying locations in Equinox
Management, you should leave it blank.
Enable maintenance mode Select to disable the device so that you can add
or remove external storage (DN) or take it out of
service (CP and DN). When a device is in
maintenance mode, it does not accept new
recordings and users cannot playback
recordings that are stored on it.
Gatekeeper IP Enter the IP address for the gatekeeper with
which you plan to register. The gatekeeper must
be the same as the one used by Equinox
Management.
Gatekeeper Service Prefix This is an optional field. Enter the service prefix
designator for this conference point. You should
leave this field as blank.
6. Click Save.
Specifying polling intervals and the network address
About this task
You must specify how frequently the Equinox Streaming and Recording communicates with the
other components, such as the conference points and delivery nodes. You must also specify the
network on which the Equinox Streaming and Recording resides. The polling interval should be in
proportion to the number of devices. The fewer the devices, the shorter the intervals. For example, if
you have over 200 delivery nodes, Avaya recommends setting the polling to 5 minutes.
The polling frequency affects the latency between the status transitions of the remote device and the
appearance of the status on the details page for the device.
Installing the new streaming and recording server
August 2017 Installing the Avaya Equinox Streaming and Recording Server 72
Comments on this document? infodev@avaya.com

Table of Contents

Related product manuals