EasyManua.ls Logo

Avaya Equinox - Page 32

Avaya Equinox
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
No. Item Icon Description
1 System
Identification Button
The identification buttons on the front and back panels can be used to
locate a particular system within a rack. When one of these buttons is
pressed, the LCD panel on the front and the system status indicator on
the back blink until one of the buttons are pressed again.
Press to toggle the system ID on and off. If the system stops responding
during POST, press and hold the system ID button for more than five
seconds to enter BIOS progress mode.
If you are directed by services to reset the iDRAC port, press and hold
the button for more than 15 seconds.
2 System
Identification
Connector
Allows you to connect the optional system status indicator assembly
through the optional cable management arm.
3 iDRAC8 Enterprise
Port
Dedicated management port.
Note:
The port is available for iDRAC8 Express features only. Avaya
systems do not come with an Enterprise license. (Not normally used
in Avaya systems.)
4 PCIe Expansion
Card Slot 1 (riser 2)
Allows you to connect a low profile PCIe expansion card.
Note:
If your server is equipped with 6 or 8 NIC ports this slot can contain
two port 10/100/1000 Mbps NIC connectors or two 100 Mbps/
1Gbps/10 Gbps SFP + connectors, 2 CPUs must be installed for
this slot to be available for use.
5 Serial Connector Allows you to connect a serial device to the system.
6 Video Connector Allows you to connect a VGA display to the system.
7 USB Connectors (2) Allows you to connect USB devices to the system. The ports are USB
3.0-compliant.
8 PCIe Expansion
Card Slot 2 (riser 3)
Allows you to connect a full-height half-length PCIe expansion card.
Note:
If your server is equipped with 6 or 8 NIC ports this slot can contain
two port 10/100/1000 Mbps NIC connectors or two 100 Mbps/
1Gbps/10 Gbps SFP + connectors.
9 Ethernet
Connectors (4)
Four integrated 10/100/1000 Mbps NIC connectors (Avaya Standard).
Note:
NIC port numbers are read from left to right, starting with Port 1,
then continuing to Ports 2, 3, and 4.
10 Power Supply
(PSU1)
Wattage and voltage type depends on configuration.
Table continues…
Installing the new streaming and recording server
August 2017 Installing the Avaya Equinox Streaming and Recording Server 32
Comments on this document? infodev@avaya.com

Table of Contents

Related product manuals