Avaya IX CU360 - Chapter 6: Troubleshooting; Avaya IX0 CU360 Monitor Display Flickers; Avaya IX0 CU360 Monitor Display is Blank; Avaya IX0 CU360 Remote Control Unit Does Not Work

Avaya IX CU360 displays PIN to enter on the screen.
5. Click OK.
Result
Avaya IX CU360 displays the shared content on the screen. The endpoint also displays alerts for
incoming calls.
Blocking all incoming calls in Avaya IX CU360
About this task
Configure Avaya IX CU360 to block all incoming calls by enabling the Do Not Disturb feature.
When this feature is enabled, Avaya IX CU360:
• Blocking all incoming call notifications.
• Automatically disconnects all incoming calls and sends a message to remote endpoints that
Avaya IX CU360 is unavailable.
Procedure
1. Do one of the following:
• From the endpoint, click Configure > Calling.
• From the web interface, click Basic Settings > Call-Answer mode > General.
2. Configure the following fields:
• Do Not Disturb: Yes
• DnD Mode: All
3. On the web interface, click Save.
Receiving calls only from Avaya IX CU360 trusted contacts
Procedure
1. Do one of the following:
• From the endpoint, click Configure > Calling.
• From the web interface, click Basic Settings > Call-Answer mode > General.
2. Configure the following fields:
• Do Not Disturb: Yes
• DnD Mode: All Except Trusted
3. On the web interface, click Save.
Blocking all incoming calls in Avaya IX CU360
March 2019 Using Avaya IX Collaboration Unit CU360 43
Comments on this document? infodev@avaya.com