Configuring Avaya IX CU360 automatically
About this task
Avaya IX CU360 prompts you to enter the service code that initiates the automatic configuration
when you start the endpoint for the first time. The administrator must provision Avaya IX CU360
for automatic configuration and to send the service code to users.
Procedure
1. Start Avaya IX CU360.
Avaya IX CU360 displays the quick setup wizard.
2. From the drop-down list, select your preferred language, and click Next.
Avaya IX CU360 displays the window to enter the service code.
3. Enter the service code.
You can enter the service code in the following two formats:
• A full 12–digit service code: The first 5 digits identify the Avaya Equinox
®
Management
server and the subsequent 7 digits identify the Avaya IX CU360 endpoint.
• A partial 5–digit service code: The 5 digits identify the Avaya Equinox
®
Management
server, while the subsequent 7 digits can be either empty or contain zeros.
Avaya IX CU360 displays the name of the Avaya IX CU360 endpoint configuration that
matches the service code.
4. Click Next.
Result
• If you entered the full 12–digit service, the Avaya IX CU360 configuration is complete.
• If you entered a partial 5–digit service code, Avaya Equinox
®
Management displays a red
clock icon against the Avaya IX CU360 name. The administrator must complete the Avaya IX
CU360 configuration, which is pushed to the endpoint.
Configuring Avaya IX CU360 manually
About this task
Manually configure the Avaya IX CU360 basic settings, such as the system name, language, and
network settings, using the quick setup wizard. Some settings might be customized for your
enterprise.
Avaya IX CU360 automatically displays the quick setup wizard when you switch on Avaya IX
CU360 or log in to the web interface for the first time.
Setting up Avaya IX CU360
March 2019 Using Avaya IX Collaboration Unit CU360 18
Comments on this document? infodev@avaya.com
To Next Page
Loading...
