Before you begin
Your computer:
• Must have the Avaya Equinox
®
client installed.
• Must be connected to the same network as Avaya IX
™
CU360. If your computer and Avaya
IX
™
CU360 are connected to different networks, NAT or a firewall must not be configured
between the two networks.
Procedure
1. Connect your computer to Avaya IX
™
CU360 using the IP address of the endpoint.
Avaya IX
™
CU360 displays the IP address on the top bar.
2. Right-click Avaya Equinox
®
, and do one of the following:
• To manually pair a device, click Screen Link > Enter a location manually.
• To automatically pair a device, click Screen Link > Search for Endpoints.
If you automatically pair a device, Avaya Equinox
®
displays the list of detected devices.
3. Do one of the following:
• To manually pair a device, enter the IP address of the device.
• To automatically pair a device, select a device.
If required, Avaya Equinox
®
prompts you to enter PIN.
4. (Optional) Enter PIN.
Avaya IX
™
CU360 displays PIN to enter on the screen.
5. Click OK.
Result
Avaya IX
™
CU360 displays the shared content on the screen. The endpoint also displays alerts for
incoming calls.
Sharing content in Avaya IX
™
CU360 meetings
About this task
You can share content from the following sources in Avaya IX
™
CU360 meetings:
• Whiteboard
• Applications
• Avaya Screen Link
• USB: You can use this source only if you connect a computer to Avaya IX
™
CU360 through
Avaya AV Grabber.
Operation
November 2019 Using Avaya IX Collaboration Unit CU360 34
Comments on this document? infodev@avaya.com
To Next Page
Loading...
