Avaya J100 Series - Page 250

Parameter name Default
value
Description
a push type and can have a value
of 0, 1 or 2.
Value Operation:
• 0: Push requests are ejected for
that push type.
• 1: Only push requests with a
mode of barge are accepted for
that push type.
• 2: Push requests with a mode of
barge or normal are accepted for
that push type.
The Push types controlled by each
digit (11111) are as follows:
• ||||+- The rightmost digit controls
top line Push requests.
• |||+-- The next digit to the left
controls display (WML browser)
push requests.
• ||+--- The next digit to the left
controls receive audio push
requests.
• |+---- The next digit to the left
controls transmit audio push
requests.
• +----- The next digit to the left
controls phonexml push requests.
PUSHPORT
80 Specifies the TCP port number to
be used by the HTTP server in the
phone for push.
Valid values are 80 through 65535.
Q
QLEVEL_MIN 1 Specifies the minimum quality level
for which a low local network quality
indication will not be displayed.
Value Operation:
• 1: Never display icon (default)
• 2: Packet loss is > 5% or round
trip network delay is > 720ms or
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 250
Comments on this document? infodev@avaya.com