Avaya J100 Series - Page 251

Parameter name Default
value
Description
jitter compensation delay is >
160ms.
• 3: Packet loss is > 4% or round
trip network delay is > 640ms or
jitter compensation delay is >
140ms.
• 4: Packet loss is > 3% or round
trip network delay is > 560ms or
jitter compensation delay is >
120ms.
• 5: Packet loss is > 2% or round
trip network delay is > 480ms or
jitter compensation delay is >
100ms.
• 6: Packet loss is > 1% or round
trip network delay is > 400ms or
jitter compensation delay is >
80ms.
R
RDS_INITIAL_RETRY_ATTEMPTS 15 Specifies the number of retries after
which the phone abandons its
attempt to contact the PPM server.
Valid values are 1 through 30.
RDS_INITIAL_RETRY_TIME 2 Specifies the number of seconds
that the phone waits for the first
time before trying to contact the
PPM server again after a failed
attempt. Each subsequent retry is
delayed by double the previous
delay.
Valid values are 2 through 60.
RDS_MAX_RETRY_TIME 600 Specifies the maximum delay
interval in seconds after which the
phone abandons its attempt to
contact the PPM server.
Valid values are 2 through 3600.
RECORDINGTONE 0 Specifies whether call recording
tone is generated on active calls.
Value Operation:
• 0: Call recording tone is not
generated (default).
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 251
Comments on this document? infodev@avaya.com