Result
If the credentials are authenticated successfully, the phone automatically restarts to complete the
connection.
Related links
Setting the network mode on page 70
Setting the network configuration
About this task
To set the network configuration to Auto or Manual. You do not need to perform this procedure if
your phone is configured to connect to Ethernet or a specific Wi-Fi network.
When network configuration is Auto, every time the phone restarts, it will connect to the pre-
configured network that your administrator has set up.
When network configuration is Manual, every time the phone restarts, it will connect to the network
that you manually configured by Setting the network mode on page 70 or Connecting to a Wi-Fi
network on page 71, irrespective of the pre-configured network that your administrator has set up.
Note:
Any time you manually change the connected network, the phone will automatically set
Network config to Manual.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll to Network, and press Select.
4. Scroll to Network config.
The Network configuration shows following two options:
• Auto: To automatically connect a network.
• Manual: To manually connect to a network.
5. Press one of the following:
• Toggle
• Right arrow key
• Left arrow key
6. Press one of the following:
• Save
• OK
Customization
July 2020 Using Avaya J169/J179 IP Phone in an Avaya Cloud Office
™
72
Comments on this document? infodev@avaya.com
To Next Page
Loading...
