At the customer site
03-300528 Issue 6 May 2009 49
18. Restore the announcement files.
Note: If you did not back up VAL announcements in Step 4, skip this step. This step can
be done using VAL Manager, if available. If the G700 was not originally
functional, VAL announcements must be rerecorded, if recorded directly to the
G700 or reinstalled if announcement files were recorded externally. Check with
the customer to see if external announcement files are available.
a. Repeat Step a
in Step 4 to enable an FTP session on the S8300.
b. Copy the backed-up announcement files from the FTP client to the G700.
- At the FTP client command prompt, type
ftp <ip-address>
where <ip-address> is the ip address of the MGP
- At the user prompt, type the ftp-username you set up in Step a
.
- At the password prompt, type the ftp-password you set up in Step a
.
- At the ftp> prompt, type bin to change to binary mode.
- At the ftp> prompt, type dir to view the contents of the /annc directory.
- At the ftp> prompt, type
put <filename>.wav
where<filename> is the name of an announcement file you want to restore.
(The put command copies the announcement file from the FTP client to the /annc
directory on the G700.)
- Repeat the put command to restore each announcement file that you backed up in
Step 4
.
c. Type bye to close the FTP session.
19. Reconnect to the G700 Media Gateway.
20. Determine which firmware to install on the G700
Conduct the following procedure to compare software versions running on the G700
processors and media modules with the versions in you downloaded from the Avaya
support Web site. If the versions do not match, new firmware for those components is
necessary.
Note: The Avaya Gateway Installation Wizard may be used for this task as well as the
upgrade of firmware — the Gateway Installation Wizard application must be
installed on the technician’s laptop.
a. At either the P333T-1(super)# or P333T-1(configure)# prompt, type dir.
The system displays the list of software.
To Next Page
Loading...
