MAPD-BD (MAPD Interface Circuit Pack TN802)
Issue 1 May 2002
8-727555-233-142
Replacing the Hard Disk
The TN802 hard drive (Note 5 in Figure 8-18) is field-replaceable.
Table 8-298. Replacing the TN802 hard drive
Step Description Comments
1. Shut down NT. Shut down Windows NT by either method
described in the ‘‘Shutting Down NT on the
TN802’’ section.
2. Remove the circuit pack. Unlatch the circuit pack, and remove it from the
carrier.
3. Remove the hard drive. Remove the 2 screws, and lift the hard drive out
of its mounting bracket.
4. Replace the hard drive. Position the new hard drive in the mounting
bracket, and replace the 2 screws (Step 3).
5. Replace the circuit pack. Slide the circuit pack into the slot, and lock the
latching lever.
6. Wait for initialization. Wait for:
■ the circuit pack to reseat (faceplate LEDs
light then go out
■ Windows NT boots (PC BOOT displays on
the faceplate LCD)
■ IP Trunk application to run (IP TRK # displays
on the faceplate LCD)
Continued on next page
To Next Page
Loading...
