Avaya S8700 - Usb1 (Modem Testing)

Maintenance Object Repair Procedure
555-233-142
8-1208 Issue 1 May 2002
USB1 (Modem Testing)
USB1 Modem Testing
This MO provides periodic and on-demand testing. The periodic test runs the
“handshake” test every 15 minutes. The on-demand tests include the
“handshake”, “offhook”, and “reset_usb” tests.
Alarm Log Entries
Notes:
a. Event ID # 1 Handshake Test failed — With three consecutive failures of
either the periodic or on-demand test, the following Minor alarm is logged:
#1,ACT,USB1,A,1,MIN,USB Modem handshake test failed
b. Event ID # 2 Modem Offhook test failed — With 3 consecutive failures of
this test, the following Major alarm is logged:
#1,ACT,USB1,A,2,MIN,USB Modem Offhook test failed
MO’s Name (in
Alarm Log) Alarm Level Initial Command to Run
1
1. Usage: testmodem [-s] | [-l] | [-t arg] | [-?]
no argument Performs “short” test.
-s Short test, performs handshake and
offhook
this is also the default option.
-l Performs “short” tests.
-t arg Specific test to perform. Possible
values for arg are: reset_usb |
handshake | offhook |
-? Usage (this).
Full Name of MO
USB1 MAJOR testmodem USB Port Modem Testing
USB1 MINOR testmodem USB Port Modem Testing
USB1 WARNING testmodem USB Port Modem Testing
Table 8-513. USB1 Alarm Log Entries
EVENT
ID#
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
1 (a) Handshake test MINOR ON testdupboard
2 (b) Modem Offhook test MAJOR ON testdupboard
Continued on next page