Avaya S8700 - Clear Errors

Maintenance Object Repair Procedure
555-233-142
8-1184 Issue 1 May 2002
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. By clearing error codes associated with the SAKI Reset test
for example, you may also clear errors generated from other tests in the testing
sequence.
Notes:
a. See ‘‘XXX-BD (Common Port Circuit Pack)’’ on page 8-1374 for
descriptions of these tests.
b. See ‘‘TONE-PT (Tone Generator)’’ on page 8-1187 for descriptions of
these tests.
c. See ‘‘TDM-CLK (TDM Bus Clock)’’ on page 8-1123 for descriptions of
these tests.
d. See ‘‘ETR-PT (Enhanced Tone Receiver Port)’’ on page 8-562 for
descriptions of these tests.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
Reset Board
Sequence D/ND
1
1. D = Destructive; ND = Nondestructive
SAKI Reset test (#53) (a) X D
Clock Health test (#46) X X ND
Control Channel Loop-Around test
(#52) (a)
XX ND
Tone Generator Crosstalk test
(#90) (b)
XND
Tone Generator Transmission test
(#40) (b)
XX ND
Tone Generator Audit/Update test
(#41) (b)
XX ND
Tone Detector Verification test
(#42) (e)
XX ND
Tone Detector Audit/Update test
(#43) (e)
XX ND
TDM Bus Clock Circuit Status
Inquiry test (#148) (c)
XX ND
TDM Bus Clock Slip Inquiry test
(#149) (c, d)
XX ND
TDM Bus Clock PPM Inquiry test
(#150) (c)
XX ND
TDM Bus Clock Parameter Update
test (#151) (c)
XX ND
Board Type Check test (#574) (c) X X ND