TONE-PT (Tone Generator)
Issue 1 May 2002
8-1195555-233-142
Tone Generator Crosstalk Test (#90)
This test checks the ability of the Tone Generator to talk on a specific time slot.
The tone generator is told to talk on a specific time slot. The other idle time slots
are checked to make sure the Tone Generator put the tone on only the specified
time slot.
Table 8-508. Test #90 Tone Generator Crosstalk Test
Error
Code
Tes t
Result Description / Recommendation
None ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT The system was not able to put the tone generation facility in the appropriate
mode to test it.
1002 ABORT The system could not allocate time slots for the test connection. This can
happen when the system is heavily loaded. If the system is not heavily loaded,
then test the TDM-BUS via the test tdm port-network PN# command.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The Tone Generator could be defective.
1. Test the IPSI circuit pack again via the test tone-clock UUC command.
2. If the test fails again, look at the Hardware Error Log for Tone Detector
circuit pack errors.
3. If there are Tone Detector circuit pack errors, see Tone Detector
maintenance documentation (‘‘DTMR-PT (Dual-Tone Multifrequency
Receiver Port)’’, ‘‘GPTD-PT (General-Purpose Tone Detector Port)’’,
‘‘CLSFY-PT (Call Classifier Port)’’, ‘‘ETR-PT (Enhanced Tone Receiver
Port)’’ to resolve these errors first.
4. If there are no Tone Detector circuit pack errors, then the IPSI circuit pack
should be replaced. See ‘‘Replacing the IPSI Circuit Pack’’.
PASS The tone generation facility is able to put tones out.
To Next Page
Loading...
