Figure 69: Single monitor video layouts with presentation
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the monitor settings. From the XT Series web interface, select Administrator
settings > I/O connections > Monitor. From the endpoint's main menu, select Configure >
Advanced > I/O connections > Monitor.
2. Select General to access the general settings.
From the endpoint interface
From the web interface
Figure 70: Configuring the general monitor settings from the web interface
3. Configure the general settings:
Table 23: Configuring general monitor settings
Field
Name
Description
Number of
monitors
Activate the HDMI ports on the XT Codec Unit which connect to a monitor: the HD1 port
and/or the HD2 port. If you are using a 4K UHD or 2160p (3840x2160) monitor, you must
connect it to the HD1 connector on the back panel. This monitor is only supported on the XT7000
Series and is only supported as the main monitor.
Table continues…
Initial Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 112
Comments on this document? infodev@avaya.com
To Next Page
Loading...
