Upgrading the Avaya Scopia
®
XT Series Software Using a USB
Drive
About this task
Your Avaya Scopia
®
XT Series can be updated by a USB drive containing the firmware.
Before you begin
Check if a later version is available by accessing the Avaya site as explained in
Updating the XT
Series on page 185. If a later version is available, download it and copy to the USB drive.
Procedure
1. Turn on the XT Series and wait for the menus to appear.
2. Insert the USB drive into one of the USB ports on the back panel of the XT Codec Unit.
Figure 131: The USB ports on the back panel
The upgrade procedure begins automatically.
Caution:
Do not shut down the XT Series until the upgrade has completed.
3. Follow the instructions displayed on the screen.
The system restarts automatically after the upgrade procedure is completed.
4. The upgrade procedure may automatically continue after the reboot, and therefore reboot
again. Wait a few minutes to ensure that the upgrade procedure is completed.
5. If the upgrade fails, see
USB Software Upgrade Failure on page 252.
Related links
Updating the XT Series on page 185
Understanding Presence
Presence is an indication of the availability of an individual at a point in time and their readiness to
communicate across a set of services such as telephony and instant messaging. The person's
Advanced Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 190
Comments on this document? infodev@avaya.com
To Next Page
Loading...
