Avaya Scopia XT7000 Series

To Next Page

To Previous Page

Verify the computer can reach the XT Series, and that a firewall does not block the following

port:

• 55099: If you have not enabled secure upgrades.

• 55090: If you have enabled secure upgrades, as described in

Enabling and Securing

Upgrades on page 186.

Figure 129: GLAN1 port

2. Verify that your computer is connected to the network using a cable.

The upgrade could take too much time through a wifi network.

3. Download the upgrade package from the Avaya site to the computer.

The XT5000/Xt4x00/XTE and XT7000 have two separate packages.

4. On the computer, launch the upgrade file.

5. Click to accept the license agreement.

6. Enter the IP address of the XT Series in the start screen and select Start.

Figure 130: Upgrading the firmware of the XT Series

The upgrade is transferred to the XT Series.

Caution:

After download begins do not shut down the XT Series until download is completed. At

the end of the update, the system reboots automatically.

7. The upgrade procedure may automatically continue after the reboot, and therefore reboot

again. Wait a few minutes to ensure that the upgrade procedure is completed.

Do not turn off the XT Series before the upgrade procedure is completed.

Avaya Scopia XT7000 Series - Page 189