Configuring Wrap-around Navigation
About this task
You can configure the XT Series to enable users to cycle among available menu items in some user
interface panels using the arrows. The selection restarts from the farthest item in the same direction,
if no other items are available.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the customization settings. From the XT Series web interface, select Administrator
Settings > System > Customization > General. From the endpoint's main menu, select
Configure > Advanced > System > Customization > General.
Figure 119: Customization — General
2. From the Wrap-around Menu menu, choose from the following options:
• Select Yes to enable wrap-around navigation. It is enabled by default.
• Select No to disable wrap-around navigation.
Note:
Wrap-around navigation is applied only to home screen panel, camera control panel,
and call control panel.
3. From the web interface only, select Save.
Related links
Advanced Configuration of the XT Series on page 128
Advanced Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 176
Comments on this document? infodev@avaya.com
To Next Page
Loading...
