Before you begin
Verify that you have the following information about your SIP environment:
• The DNS name or IP address of the SIP server. You can define up to three servers.
• The transport protocol and port used in your SIP environment.
• (Optional) The model of the SIP server.
• For the SIP infrastructure that requires a SIP user authentication, credentials for authenticating
XT Series to the SIP server.
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the SIP settings. From the XT Series web interface, select Administrator Settings >
Protocols > SIP. From the endpoint's main menu, select Configure > Advanced >
Protocols > SIP.
From the endpoint interface
From the web interface
Figure 81: Configuring SIP settings
2. Enter your system’s name (or number) and the SIP server’s information, used to register and
authenticate the XT Series with the SIP server:
Table 28: Configuring SIP-related parameters
Parameter Description
User Enter the system name (or number). The system is
registered to the SIP server under this name.
When connecting over SIP, this name is displayed on the
monitors participating in the videoconference (for
example, John-Smith, or 9th-Floor-Room) .
Authentication Name If necessary, enter the name for authenticating the XT
Series with the SIP server. It can be the same as the
User parameter.
Table continues…
Registering the XT Series to a SIP Server
January 2017 Avaya Scopia
®
XT Series Deployment Guide 125
Comments on this document? infodev@avaya.com
To Next Page
Loading...
