Procedure
1. Access the XT Series's echo cancellation settings. From the XT Series web interface, select
Administrator settings > I/O connections > Echo Canceller. From the endpoint's main
menu, select Configure > Advanced > I/O connections > Echo Canceller.
Figure 102: Configuring echo cancellation
2. Set the fields as required.
Table 44: Configuring echo cancellation settings
Field Name Description
AGC Enables/disables AGC. Automatic Gain Control (AGC) smooths audio
signals through normalization, by lowering sounds which are too strong and
strengthening sounds which are too weak.
Typically, you enable AGC for optimal audio. However, you may want to
disable it if your microphone is strengthening the sound of background
noise, mistaking it for your voice.
Noise reduction Enables/disables reduction of background noise in a conference room (like
coughing, paper rustling, or the hum of an air conditioning system).
Typically, you enable Noise reduction for optimal audio. However, you
may want to disable it some voices are filtered out as background noise,
which causes breaks in the audio.
Audio delay
automatic estimation
An HDMI monitor might cause a delay in the audio, causing an echo.
Set this field to Yes to improve its echo cancellation performance
automatically. We recommend this setting when you connect a new monitor
to the XT Series.
If you set this field to No, you can generate the audio delay manually and
train the echo cancellation to use the resulting audio for better
performance. For details, see Cancelling the Echo on HDMI Monitors on
page 233.
Audio delay Select Yes to use the estimated audio delay.
Typically, you enable Audio delay for optimal audio. However, you may
want to disable it if your room has a strong echo that creates a
reverberating effect, which may produce false results when estimating the
audio delay.
Advanced Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 156
Comments on this document? infodev@avaya.com
To Next Page
Loading...
