3. To store a new preset position:
• From the new XT Remote Control Unit, press ok/menu and select Presets, then press
the new position number (0-9).
• From the previous version of the XT Remote Control Unit, press the Presets > Memo key,
then press the new position number (0-99). To save positions 100-109, press * then 0-9.
For 110-119, press # then 0-9.
• From the XT Series web interface, select select Store on the row of the new position
number.
Figure 113: Storing a camera preset
4. To save your choice on the endpoint, press ok/menu.
The position number of the preset turns blue, indicating it was successfully stored.
Figure 114: Camera position stored successfully on the endpoint interface
On the web interface, the Assigned column now contains a check mark.
5. To delete a previously stored position with the XT Remote Control Unit, press its number and
then press the Delete key.
From the web interface, select Delete on the row of the position number.
Related links
Advanced Configuration of the XT Series on page 128
Advanced Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 172
Comments on this document? infodev@avaya.com
To Next Page
Loading...
