If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the SNMP management settings. From the XT Series web interface, select
Administrator Settings > Utilities > Remote Access > SNMP. From the endpoint's main
menu, select Configure > Advanced > Utilities > Remote Access > SNMP.
Figure 127: Configuring SNMP settings
2. Set the fields as required.
Table 54: Configuring SNMP settings
Field Name Description
SNMP management Select Yes to enable an SNMP server.
Administrator name (Optional) Enter a contact name to enable SNMP management for this
device which would appear in an SNMP browser.
Location (Optional) Enter the location of the device, which would appear in an
SNMP browser.
Community Enter the name of the SNMP community that supports the read operations
of SNMP management. Equinox Management requires the name to
communicate with the gateway in the SNMP Get/Set Community fields.
The community values are case-sensitive. Typically there is a separate
community for read (GET) called public and a community for write (SET)
called private.
Enable all addresses Select No to restrict SNMP remote access for read operations to specific
computers in the range of the Address and Subnet Mask fields below.
Table continues…
Advanced Configuration of the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 184
Comments on this document? infodev@avaya.com
To Next Page
Loading...
