Camera
Solution
Make sure the camera is connected to the HD CAM1 input port of the XT Codec Unit.
Control Camera setting
The Control Camera setting is not enabled.
Solution
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
1. Access the general camera settings. From the XT Series web interface, select
Administrator Settings > I/O connections > Cameras > HD1. From the endpoint's main
menu, select Configure > Advanced > I/O connections > Cameras > HD1.
Figure 185: Enabling the Control Camera setting from the web interface
2. Make sure that the Control Camera field is set to Yes.
Troubleshooting the Avaya Scopia
®
XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 240
Comments on this document? infodev@avaya.com
To Next Page
Loading...
