Avaya Scopia XT7000 Series - Page 59

XT Camera Switch
Connected to XT5000
XT Camera Switch
Connected to XT7000
Second Camera
First Camera
Figure 31: Connecting the second camera
• Attach one end of the VISCA control cable to the IN RS-232C connector on the
second camera.
• Attach the other end to the OUT RS-232C connector on the previous camera.
b. Connect the DVI-HDMI cable:
• Attach the DVI connector to the DVI socket on the second camera.
• Attach the HDMI connector to the HDMI socket labeled 2 for the XT5000 Series and
to the socket labeled 1 for the XT7000 Series on the Avaya Scopia
®
XT Camera
Switch.
6. If required, repeat the above step for a additional HDMI devices.
7. Check that the SYSTEM SELECT switch on the back panel of each camera is set to 7:
This is only for Premium, Advanced, and Standard II cameras.
Figure 32: Checking the SYSTEM SELECT switch
Caution:
To adjust the switch, you must first turn the camera off. Adjust it using a slotted 2.5 mm
screwdriver.
8.
Turn on the XT Codec Unit by pressing the
power key on the XT Remote Control Unit.
This also turns on the Avaya Scopia
®
XT Camera Switch.
Connecting Cameras or DVD players
January 2017 Avaya Scopia
®
XT Series Deployment Guide 59
Comments on this document? infodev@avaya.com