Standby or activate.
Press and hold to
switch off.
Enter numbers or characters.
Hold to recall preset.
Open Contacts
Dial a call
Disconnect or
end a meeting
Press and hold
to toggle Do not disturb
Press to select a menu item.
Long press to change input mode.
Back/undo.
Toggle graphic
menu on
home page.
Press to delete.
Hold to clear.
Toggle graphic
menu everywhere.
Start/end
presentation
(Arrow keys)
Navigate menus.
Move camera.
Press red and green keys
to activate programming mode.
Enter two digits to program.
Zoom
Volume
Press to toggle video mute.
Hold to toggle Do not disturb.
Press to toggle audio mute.
Hold to toggle privacy.
Help
Press to change input source.
Hold to toggle local/remote.
Press to change multi-image type.
Hold to toggle Open layout page.
Change layouts
Press to select
far end
Press to select
near end
Press Memo then enter
two digits to position
near camera as preset.
Press Select then enter
two digits to select
saved near or far preset.
Figure 42: The XT Remote Control Unit (Advanced)
Enter letters and digits into a field using the remote's keypad on the XT Remote Control Unit. The
system displays the current entry method to the right of the field (Figure 43: Entry method displayed
to the right of an input field on page 75). You can switch entry methods by pressing the 1/a/A
button repeatedly while the cursor is in the input field, to switch between abc1 (default) for lower
case alphanumeric characters, ABC for upper case characters only (no digits), abc for just lower
case characters only (no digits), and 123 for digits only. To enter a letter or number, press a key
repeatedly to cycle through its characters.
Controlling the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 74
Comments on this document? infodev@avaya.com
To Next Page
Loading...
