For more information on adding, removing and upgrading the system remotely in Equinox
Management, or for details on synchronizing contacts for the endpoints in your organization, see
Administrator Guide for Avaya Equinox Management.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the Equinox Management remote access settings. From the XT Series web
interface, select Administrator Settings > Utilities > Remote Access > Equinox
Management. From the endpoint's main menu, select Configure > Advanced > Utilities >
Remote Access > Equinox Management.
Figure 48: Managing the XT Series from Equinox Management
2. Set the fields as required.
Table 12: Granting remote access to Equinox Management
Field Name Description
Mode If you intend to auto-provision the XT Series from Equinox
Management, select Cloud and continue to Provisioning Avaya
Scopia
®
XT Series Endpoints Automatically on page 84.
If you intend to provision each XT Series locally, select Local. If you
select Local, the Automatic IP Address and IP Address fields are
displayed.
Note:
Please note that Cloud is not supported by Scopia
Management 8.3.x. If your deployment is not updated to
Equinox Solution, please set the Mode to Local.
URL This is a read-only field and cannot be edited.
This field might contain the URL of the Equinox Management which
moved the XT from local management to cloud management. This
Table continues…
Controlling the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 82
Comments on this document? infodev@avaya.com
To Next Page
Loading...
