Note:
• If you connect two ports explicitly set for different speeds (for example one configured as
10BaseT and the other as 100BaseTX) the port link LED may indicate a link, but the switch
does not establish a link. Connect ports using the same set speed or use auto-negotiation
on each switch.
• The port Link/Activity LEDs graphically represented in EDM are always steady once a link
is established. They do not blink to reflect port traffic activity.
Installing the Avaya VSP 4000 4850GTS Series
May 2016 Installing Avaya Virtual Services Platform 4850GTS Series 40
Comments on this document? infodev@avaya.com
To Next Page
Loading...
