To ping or traceroute the far site device.
Select
Network
│
Test Utilities
and press .
Select
Test Command
and press
.
-
Ping:
Ping is used to test the reachability of
a host on an Internet Protocol (IP) network,
and to measure the round-trip time for
messages sent from the originating host to
a destination and echoed back to the
source.
-
Traceroute:
traceroute is displayed the
route (path) and measuring transit delays
of packets across an Internet Protocol (IP)
network.
IP Address:
Enter the IP address of device that
user wants to ping or traceroute.
Finally, select
Run
to start ping or traceroute.
To Next Page
Loading...
