35146AJ
16
SETTING UP THE RECORDER FOR THE
FIRST TIME
1. Plug the supplied power cord into the recorder. Do NOT connect
the power cord to a power source at this time.
2. Connect the network cable intended for remote connection to the
Internet NIC.
Note The External Switch NIC is intended for use with a dedicated
camera network with an accessory PoE Switch.
1. Connect the supplied keyboard and mouse using the
rear USB ports.
2. Connect a monitor using the HDMI or VGA ports.
3. Connect the cameras to PoE ports, if available.
4. Connect the power cord to a power source, and then
turn the recorder ON.
5. Log in to the ProConnect recorder using the default
credentials:
• Username: admin
• Password: 1234
6. Follow the Setup Wizard to complete basic setup of your
system.
TURNING ON THE RECORDER
1. Turn on the monitor connected to your recorder.
2. Use the power switch on the rear of the recorder to turn the
recorder ON.
3. The recorder will run a series of self-tests. If asked to respond to
any messages, follow the instructions carefully.
Startup is complete when the ProConnect software is finished loading
and displays the main login screen.
TURNING OFF THE RECORDER
1. Click Setup, and then click Power Off / Restart.
2. Click Power Off.
To Next Page
Loading...