3 — Operation
3 - 8 Service Instructions RP-A301CE/RP-A351CE/RP-A355CE
How to load the product to be cut
The load operations of the product to be
cut are the same for both the manual and
the automatic operation.
1. Check that the slicer is off and
position the slice thickness control to
zero.
2. Push the product holder towards the
operator.
3. Lift and rotate the slice thickness
control outwards.
4. Place the product to be cut against
the wall of the product holder.
5. Position the last slice device on the
product to be cut far from the slice
thickness plate. The product is fed to
the slice thickness plate by gravity
making the cut easier.
To Next Page
Loading...