Avery Weigh-Tronix XLR Series User Manual

XLR-6, XLR-8 and XLR-12 Installation Instructions 19
3.6.6 Setup for Digi-Star Indicators
When using the XLR Series remotes with Digi-Star indicators:
1. Connect the XLR to the J-903 Remote port on the EZ-III indicator models (XLR
series is not compatible with EZ-II indicator models.)
Use the AWT Digi-Star interface cable from Avery Weigh-Tronix (PN
AWT25-500928 or AWT25-500929) or the standard cable supplied by
Digi-Star.
2. Follow instructions below based on the Digi-Star model of indicator you are
interfacing to.
Avery Weigh-Tronix XLR series cables for interfacing to Digi-Star
indicators
l AWT25-500928 15 ft / 4.6 m Cable Assembly, Interface to Digi-Star
l AWT25-500929 30 ft / 9.2 m Cable Assembly, Interface to Digi-Star
EZ3 Indicators with full alpha and alphanumeric keypad (GT460, NT460,
EZ4600, EZ3600V, EZ3400VL, and EZ3400)
1. Enter 234 and press Select.
2. Press Select until EZ3MUX is displayed.
3. Press Enter.
EZ3 Indicators with alphanumeric keypad (EZ2500V, EZ2400V, EZ400,
and GT400)
1. Press Net/Gross first and then press On and hold them both down at the same
time until scrolling message "Press Select or Net…." appears.
2. Press Select until Menu2 appears and press On.
3. Press On until RMDisp appears then the current selection appears (EZ3MUX
or EZ2).
4. Press Select until EZ3MUX appears then press On.
5. Cycle power by turning the indicator off then back on or press On until you get
into weighing mode.

Avery Weigh-Tronix XLR Series Specifications

General

Brand	Avery Weigh-Tronix
Model	XLR Series
Category	Monitor
Language	English