EN13EN 12
C - INSTALLATION
Please note: there will be significant force on the mounting bracket when the motor drive is running. We
recommend sealing threaded rods at least 15 cm in length. If the post is made of metal, we recommend
welding or passing the threaded rods through to secure them with self-locking nuts.
Consult a professional if in doubt.
Attaching the gate bracket to the motor
Assembling the motor to the post bracket
Please note: the motor must be turned so that the wire is at the bottom
Remember to add the spacers on both sides of each mounting bracket.
To Next Page
Loading...
