(Optional) Mounting the Dome Camera to the Pendant Wall Mount 31
(Optional) Mounting the Dome Camera to the Pendant Wall Mount
If the dome camera will be using the pendant wall mount, you will need to install the NPT adapter as well.
1. Determine where the cables will enter the pendant wall mount.
l
If the cables will be pulled from inside the mounting surface, use the cable entry hole at the rear of the
pendant wall mount.
l
If the cables will be coming out of an external conduit pipe, use the 3/4” NPT pipe entry hole on the
bottom of the pendant wall mount.
2. Use the provided mounting template to drill four mounting holes into the mounting surface.
l
If you are using the rear cable entry hole, also drill the cable entry hole into the mounting surface.
3. Place the pendant wall mount bracket on the mounting surface and screw it in using the provided screws. Pull
cables through the wall mount bracket if using rear cable entry.
4. Insert the pendant wall mount over the bracket mounting tabs. Pull cables through the arm if you are using the
rear cable entry hole.
To Next Page
Loading...
