Avigilon H4 Installation Guides

b. The PoE cable will be routed through the largest cable opening on the bottom of the enclosure.
c. Use the sealing ring to seal the cable connection through the enclosure. Ensure that the unused
holes on the bottom of the housing are sealed with the remaining sealing rings to prevent water
from entering the housing.
NOTE: You will need to crimp the PoE cable to pull the wire through the sealing ring.
Mounting the Feed Through Mounting Arm 11

Avigilon H4 Specifications

General

Sensor Type	CMOS
Impact Protection	IK10
Camera Type	Dome
Day/Night	Yes
Video Compression	H.264
Wide Dynamic Range (WDR)	120dB
Power	PoE (IEEE 802.3af)
Operating Temperature	-40 °C to +50 °C (-40 °F to +122 °F) depending on the model
Ingress Protection	IP66
Onvif Compliance	Yes
IP Rating	IP66
Power Supply	12VDC or PoE