Important Safety Information
This manual provides installation and operation information and precautions for the use of this device. Incorrect
installation could cause an unexpected fault. Before installing this equipment read this manual carefully. Please
provide this manual to the owner of the equipment for future reference.
This Warning symbol indicates the presence of dangerous voltage within and outside the product
enclosure that may result in a risk of electric shock, serious injury or death to persons if proper
precautions are not followed.
This Caution symbol alerts the user to the presence of hazards that may cause minor or moderate injury
to persons, damage to property or damage to the product itself if proper precautions are not followed.
WARNING — Failure to observe the following instructions may result in severe injury or death.
l Installation must be performed by qualified personnel only.
l Installation of the device must conform to all local codes.
l Power supply to the product must be exclusively provided by Power over Ethernet (PoE).
l Do not connect directly to a mains power system for any reason.
CAUTION — Failure to observe the following instructions may result in injury to persons or damage to
the device.
l Do not expose the camera directly to high levels of x-ray, laser, or UV radiation. Direct exposure to high
levels of x-ray, laser, or UV radiation may cause permanent damage to the image sensor.
l Do not install near any heat sources such as radiators, heat registers, stoves, or other sources of heat.
l Do not subject the device cables to excessive stress, heavy loads or pinching.
l Do not open or disassemble the device. There are no user serviceable parts.
l Refer all device servicing to qualified personnel. Servicing may be required when the device has been
damaged (such as from a liquid spill or fallen objects), has been exposed to rain or moisture, does not
operate normally, or has been dropped.
l Do not use strong or abrasive detergents when cleaning the device body.
l Use only accessories recommended by Avigilon.
l This product should be installed in restricted access locations.
WARNING — The electrical system to which the unit is connected must be equipped with an automatic
bipolar circuit breaker. The circuit breaker for main supply voltage phase units must have a level of
intervention of 20A max. The circuit breaker for low voltage units must have a level of intervention of 6A
max. This circuit breaker must be of the Listed type. The minimum distance between the circuit breaker
contacts must be 3 mm (0.1"). The circuit breaker must be provided with protection against the fault
current towards the ground (differential) and the overcurrent (magnetothermal).
2
To Next Page
Loading...
