Note: For cameras with 2 microSD card slots, the camera will record video to SD cards in both slots.
The total storage capacity of the system is the combined storage capacity of each of the two
individual cards.
1. On the Storage page, select the Enable Onboard Storage check box.
2. By default, the camera is set to only record to the SD card when it is unable to communicate with the
network video management server. If you prefer to have the camera record video to both the network
video management server and to the SD card, clear the Record only when server connection is
interrupted check box to disable the setting.
3. Select one of the following recording modes:
l
Continuous: the camera never stops recording to the SD card.
l
On Motion: the camera only records when there is motion in the scene.
If you are configuring an Avigilon video analytics camera, the On Motion setting will record
either pixel change in the scene or analytics motion events depending on how the camera is
configured in the Avigilon Control Center Client software.
The recorded video will be divided into files no more than five minutes in length or 100MB in size.
4. On the Compression and Image Rate page, make sure the format is set to H.264 or H.265 to
maximize the SD card recording capacity and performance.
ONVIFProfile G
ONVIF Profile G allows video management systems to retrieve video from a camera's onboard storage when
there is a gap in the VMS video due to a network outage or similar event.
l
Cameras with firmware versions 4.4.0.X or later will have ONVIF Profile G already enabled.
l
Note: Enabling ONVIF Profile G will require reformatting the SD card. You will lose all footage
currently recorded on the SD card. Ensure that you download any required video clips before
enabling Profile G.
Onvif is a trademark of Onvif, Inc.
Downloading Recorded Video from the Web Interface
Listed in the Recordings section are all the videos that have been recorded to the SD card.
If you are using two SD cards you will have to select the SD card that you want to download video from. You
may have to check both SD cards for the recording you want to download. The camera can record video to
either SD card based on the remaining capacity of the SD cards.
It is recommended that you download recorded video from the web interface. However, if your bandwidth is
ONVIFProfile G 21
To Next Page
Loading...
Need help?
General
