General
When you select Setup, the first page you see is the General page. The General page allows you to set the
camera's identity.
Tip: Features and options are disabled if they are not supported by the camera.
Note: If a camera with video analytics or unusual motion detection is physically moved or adjusted,
or if the focus or zoom level is changed, reset the learning progress to provide accurate results. If the
camera's image rate and compression or display settings are updated, the learning progress may
reset automatically.
1. In the Name field, give the camera a meaningful name.
2. In the Location field, describe the camera's location.
3. Select the Disable device status LEDs check box to disable the LED indicators located on the camera.
4. From the Mode drop-down list, select the mode that the camera will operate in.
This option is only displayed for higher bandwidth usage cameras.
l
Full Feature — This is the standard operating mode. Offers the full functionality of the camera.
l
High Framerate — The 2MP and 4MP camera models have a High Frame Rate mode, allowing
these cameras to reach higher frame rates while disabling analytics.
ModelsFeatures Impacted by High Framerate
2 MP H6A Cameras
2 MP H6X Cameras
4 MP H6ACameras
4 MP H6XCameras
o
Increased maximum frame rate
o
Analytics disabled
l
No Smart Analytics — This mode will disable smart analytics. This option is for deployments
where camera based video analytics would interfere with other analytics integrations.
5. Select any of the Overlay Setting check boxes to display and stamp that information on the camera's
video stream. The options are:
l
Display Date
Selecting the Display Date check box also enables the Date Format drop-down list. From the
list, choose the date format which will be used to display the date.
l
Display Time
General 5
To Next Page
Loading...
Need help?
General
