Avigilon SDC - Add Multiple Sdcs Using Quick Start Option; Add One SDC

Add multiple SDCs using Quick start option
1. Go to control.openpath.com/loginand sign in. To access the European Alta Control Center, go to
control.eu.openpath.com/login.
2. Go to Administration > Quick start.
3. Enter a Site nameand any other relevant site information.
a. In Organization language, select the preferred language for the emails sent by the system.
b. Click Next.
4. Enter the number of controllers located at your site:
a. Enter names for the controllers.
b. In Controller type, select Single Door Controller (SDC).
c. If your SDC also connects to an expansion board, add the appropriate types in EXPANSION
BOARDS:
l
Openpath 4-Port Expansion
l
Openpath 8-Port Expansion
l
Openpath 16-Port Elevator
Tip: This configuration is most common with the Core Series Smart Hubs.
5. Enter the number of readers connected to the controllers. Enter their names and click Next.
6. Review your site details and click Confirm & Submit. It may take a few minutes for setup to complete.
Add one SDC
1. Go to Devices > ACUs.
2.
To add a new SDC, click the button in the upper-right corner.
3. Enter a name for the SDC.
4. In Controller type, select Single Door Controller (SDC).
5. If your SDC also connects to an expansion board, add the appropriate types in EXPANSION BOARDS:
Provisioning 17