Avigilon SDC - Test Internet Connection Using Open Admin App; Configure Network Settings Using Open Admin App; Change Network Settings; Set up Wi-Fi on the SDC

7. Tap the ACU Name that you want to provision to (this is the name of the SDC you created in the Alta
Control Center), and then tap Yesto proceed.
8. Optional. Tap Provision with Static Cloud IP, if the Static Cloud IP toggle is enabled in the Alta Control
Center.
9.
When setup is complete, the Status LED will change to solid white .
Test internet connection using Open Admin app
In the Open Admin app, you can tap Test Internet Connection to check if the SDC can ping
https://api.openpath.com/health.
Configure network settings using Open Admin app
In the Open Admin app, you can configure network settings for the SDC. While wired Internet connections are
preferred, you can configure the SDC to use Wi-Fi instead. The default interface for the SDC is Ethernet/wired
connection. Ethernet and Wi-Fi connections can be DHCP (default) or can have a static IP address.
The SDC supports 2.4 GHz and 5 GHz Wi-Fi connections.
Change network settings
1. Connect to the SDC by pressing the Admin button again, if needed.
2. Tap on Network Settings.
3. Select Configure network manually.
4. Configure the network settings as needed. Set a static IP address or set a preferred DNS server.
5. Tap Saveon the top-right corner.
Set up Wi-Fi on the SDC
1. Connect to the SDC by pressing the Admin button again, if needed.
2. Tap on Network Settings.
3. Tap on Wi-Fi IP Settings.
4. Enable Default Interface.
Provisioning 20