separate.
NOTE:
Use blank white paper.
Set the scaling to 100%. The sheet is not
recognized correctly when printed in a size smaller
than the original.
Do not use toner saving mode. The sheet is not
recognized correctly when the print is too light.
Do not use thin paper in order to avoid bleed-
through from the back.
When you copy a patch code sheet that you printed
out, make sure to copy by the same size and
brightness as the original copy.
Use the same sheet repeatedly may decrease the
recognition accuracy due to accumulated dirt on the
sheets. If the sheet is not recognized correctly or
gets smudged, replace it with a new sheet.