ScanCopier
6-1
6. TROUBLESHOOTING
6.1 Troubleshooting Flowchart
6.2 Tables
This section is given to locate and resolve the causes of troubles so as the ScanCopier is always in good
working condition. The trouble modes, relevant units and maintenance methods are described below.
When a problem occurs, troubleshoot the problem according to the symptoms it shows.
Check the following first:
1. Is anything operating improperly?
2. Does the problem recur, or is it regular?
Figure 6.1 to Figure 6.3 show the troubleshooting flowcharts.
The causes and maintenance methods for each failure mode are described in Table 6.1 through 6.7
To Next Page