ScanCopier
8-4
8.3 PROCEDURE FOR DISASSEMBLY AND REASSEMBLY
8.3.1 NOTES ON DISASSEMBLY
(1) Clean the disassembly and assembly location.
(2) Disconnect the power cable and remove the AC plug from the outlet before disassembly
and assembly.
(3) Follow the disassembly and assembly procedures. Never loosen the screws of parts that
must not be disassembled.
(4) Store the disassembled parts in a clean place to avoid loss.
(5) After replacement, check the contacts and spare part mounting.
(6) Assemble the parts in reverse order of disassembly procedure.
8.3.2 DOCUMENT COVER
(1) As shown in the figure below, lift the document cover to remove the studs from the hinge holes.
The studs are loosely attached to the hinge holes in the purpose to cover your original when it is
a few inches high.
Figure 8.2 Document cover removal
Document cover
Hinge hole
Stud
To Next Page