Avision ScanCopier - Lubricants; Mechanical Unit Lubrication

ScanCopier
8-2
8.2 LUBRICANTS
This section describes the items to check and the places to lubricate when maintenance parts are
replaced.
8.2.1 MECHANICAL UNIT LUBRICATION
This lubrication method:
1 - A - C - Y
1. Positions need to be lubricated:
The positions need to be lubricated is indicated in numbers.
2. Lubricant type:
A: Shell Alvania Grease No. 2
B: Shell Terrace Oil 46
3. Amount of lubricant:
C: Coat thinly uniformly
4. Lubrication cycle:
Y: Every year
Table 8.2 below shows the position to be lubricated.
Lubrication
Position
Lubricant
Type
Lubricant
Amount
Lubrication
Cycle
Lubrication
Position
1 B C Y Sliding
rod
2 A C Y Sliding
frame
Table 8.2
Positions need to be lubricated
(show in number)
Lubricant type
Amount of lubricant
Lubrication cycle