ScanCopier
3-1
3. UNPACKING, INSTALLATION, AND
TRANSPORTATION
3.1 Precautions of Installation
3.2 Unpacking Procedure
3.3 Installation
3.4 Placing the Original
3.5 Transportation
3.1 PRECAUTIONS OF INSTALLATION
Pay attention to the following matters before unpacking and installation.
• Do not install in a place where vibration may occur.
• Keep the ScanCopier out of direct sunlight. Do not install near a heat source.
• Do not place the ScanCopier around materials which shut off the circulation of air.
• Do not install in a humid or dusty place.
• Use care not to scratch the glass surface of the ScanCopier or the document holding pad
with a clip or staple.
• Do not use the wall socket with connecting devices which may generate noise, for example,
air-conditioner, etc.
• Use a suitable AC power source.
• Place the ScanCopier on a level surface.
3.2 UNPACKING PROCEDURE
Unpack the ScanCopier according to the following procedure.
• Remove the packing material.
• Remove the ScanCopier from the shipping container.
• Remove the ScanCopier from the PVC bag.
• Check the items by referring to Figure 3.1.
• For any missing items, please contact your nearest dealer or distributor.
Note: Keep all the packing material in case you may need to return the ScanCopier.
To Next Page
Loading...